Wireless Digital Swimming Pool, Fish Pond Remote Online PH Monitor

This product is a special tool for measuring water quality, suitable for the measurement of chemical reaction tanks (towers), chemical sedimentation tanks (towers), reaction kettles, tap pools, swimming pools, fish ponds, baths, etc. The wireless remote digital acidity meter is composed of a transmitter and a receiver. The transmitter is sealed and waterproof. It is placed in the tested solution pool to measure the pH value of the solution, and the data is wirelessly transmitted to the receiver. People can use the receiver to Observe the pH value of the measured solution pool at a distance.

Function description:

1. Remotely monitor the pH of the solution pool 2. The transmitter (pH stick at the measuring end) transmits the pH value to the receiver (display end) through a wireless signal 3. The open distance of data transmission is up to 80 meters 4. The transmitter is sealed and waterproof structure, which can be placed in the solution tank 5. A receiver can have up to 6 transmitters, and the pH value sent by the 6 transmitters will be displayed in turn. 6. Each set of instruments has a unique address code when they leave the factory. When multiple sets of instruments work together, the receiver only receives the signal from the set of transmitters, and different sets do not affect each other. 7. The electrode can be replaced and the electrode is completely waterproof.

SPecifications:

1.Transmitter Measuring Range: 4.1-8.8PH Resolution: 0.1PH Accuracy: +0.1PH Automatic Temperature Compensation: 0°C~50°C Calibration: 2 points with auto buffer recognition or one point with auto buffer recognitionDisplay: LED Power Supply: 3 x 1.5V(AA Batteries) (not included) 2. Receiver Display: Dual-level LCD The distance range: 80 meters Power Supply: DC6V Dimensions: 100 x 146 x48 mm

Operational Guide :

The transmitter with a receiver to PH monitoring at a distance It can also be used alone, measurement of solution PH value. 1.The receiver's operating is simple Connect the power and press power button start up or shutdown. 2. The using steps of transmitter: 1) Pull off protective cap of transmitter(do not twist off) and place it in solution to be measured (you can use the rope fixed drift section) This will automatically turn on the transmitter, the LED indicator PH value, at the same time, the data transmitted to the receiver. 2) After use, remove the transmitters in the pool from the solution. equipment automatically power off. 3) And rinse probe in fresh water and place protective cap back on. Note: 1. When the PH value is lower than 4.1, the LED display 4.0;the PH value is higher than 8.8, the LED shows 8.9. 2. The transmitter boot after 4 minutes non-stop measurement display and send the PH value: Entered hibernation after 4 minutes close the LED display, measuring per minute and send the PH value at a time. 3. If not use, please remove the transmitter from the solution in the pool, in order to avoid the waste of the battery.

Packing list :

1 * PH-029 display 6 * Sensors